NEC Electra Elite IPK II Programming Manual page 143

Document Revision 1
Item
No.
03
04
05
06
07
08
09
10
11
2 - 108
Item
Extension Ring Tone
Use this option to set the tone (pitch) of
the incoming extension call ring for the
extension port you are programming.
Also see program 15-08.
Redial (Speed Dial) Control
Use this option to control the function of
the extension's Redial key when used
with Speed Dialing. The Redial key can
access either the Common or Group
Speed Dialing numbers.
Transfer Key Operation Mode
Use this option to set the operating
mode of the extension's CONF key. The
keys can be for Call Transfer, Serial
Calling or Flash. When selecting the
Flash option (selection 2), refer also to
Program 81-01-14.
Hold Key Operating Mode
Use this option to set the function of the
Multiline Hold key. The Hold key can
activate normal Hold or Exclusive Hold.
Automatic Hold for CO Lines
Automatic Handsfree
Use this option to set whether pressing
a key access a One-Touch Key or if it
pre-selects the key.
--- Not Used ---
Ringing Line Preference for Trunk
Calls
Use this option to select between Idle
and Ringing Line Preference for trunk
calls.
Callback Automatic Answer
Use this option to enable or disable
automatic answer for Callback. If
enabled, extension automatically
answers Callback ring when user lifts
the handset. If disabled, use must press
line appearance key to answer
Callback.
Input Data
1 = High
2 = Medium
3 = Low
4 = Ring Tone 1
5 = Ring Tone 2
6 = Ring Tone 3
7 = Ring Tone 4
8 = Ring Tone 5
0 = Common and
Individual Speed
Dialing
1 = Group Speed Dialing
0 = Transfer
1 = Call back
2 = Hook
0 = Normal (Common)
1 = Exclusive Hold
0 = Hold
1 = Disconnect (Cut)
0 = Pre-select
1 = One-Touch
(Automatic
Handsfree)
0 = Idle (Off)
1 = Ringing (On)
0 = Off
1 = On
Program 15 : Extension, Basic Setup
Electra Elite IPK II
Related
Default
Program
8
0
0
0
1
1
1
1