NEC Electra Elite IPK II Programming Manual page 187

Document Revision 1
Input Data (Continued)
Item
Item
No.
07 Time and Date Display Mode
Set how the Time and Date appear on
display telephones. There are eight
display modes.
08
LCD Display Holding Time
09 Disconnect Supervision
Use this option to enable or disable
disconnect supervision for the system
trunks.
Time Before Shifting to
10
Power-Saving Mode
11 Handsfree Microphone Control
Use this option to control the setting
for Multiline Terminal's Handsfree
microphone after being disconnected
and reconnected. If set to 0, the
microphone will always be off when
the terminal is reconnected. If set to
1, the microphone will remain in the
same state it was in when the
terminal is reconnected.
12 Forced Intercom RIng (ICM Call
Type)
Use this option to enable or disable
Forced Intercom Ringing. If enabled,
incoming Intercom calls normally ring.
If disabled, Intercom calls voice-
announce.
13 --- Not Used ---
14 Headset Ringing Cancel Timer
2 - 152
Input Data
1~8
Type 1: (12 hour) 10 MAR TUE 3:15PM
Type 2: (12 hour) 3:15PM MAR 10 TUE
Type 3: (12 hour) 3-10 TUE 3:15 PM
Type 4: (12 hour) 3:15PM TUE 10 MAR
Type 5: (24 hour) 10 MAR TUE 15:15
Type 6: (24 hour) 15:15 MAR 10 TUE
Type 7: (24 hour) 3-10 TUE 15:15
Type 8: (24 hour) 15:15 TUE 10 MAR
0-64800 seconds
0 = Disable (Off)
1 = Enable (On)
0 = No
1 = 1 minutes
2 = 2 minutes
3 = 4 minutes
4 = 8 minutes
5 = 16 minutes
6 = 32 minutes
7 = 64 minutes
0 = Off
1 = On
0 = Disable (Voice)
1 = Enable (Signal)
0~64800 seconds
Electra Elite IPK II
Default
Programming
3
5
1
0
1
0
30 sec.
Program 20 : System Option Setup
Related
15-02-18