Service Tone Timers - NEC Electra Elite IPK II Programming Manual

Electra Elite IPK II
Level:
IN
Description
Use Program 20-18 : Service Tone Timer to set the values for the system service
tone timers. Refer to the following chart for a description of each option, its range and
default setting.
Input Data
Item
No.
01
02
03
04
05
06
07
08
09
Electra Elite IPK II Programming Manual
Program 20 : System Option Setup
Item
0~64800
Extension Dial Tone
Time
Busy Tone Timer 0~64800
Congestion Tone 0~64800
Call Waiting Tone 0~64800
Timer
Multiline Confirmation 0~64800
Tone
Interval of Call 0~64800
Waiting Tone
Intrusion Tone Repeat 0~64800
Time
Conference Tone 0~64800
Interval
Warning Beep Tone 0~64800
Signaling Interval

20-18 : Service Tone Timers

Input
Default
Data
30
After getting Intercom dial tone,
seconds
a keyset user has this interval
to dial the first digit of the
Intercom call.
15
seconds
10 A Busy Tone when system
seconds
resources run short. (such as
DTMF receiver resources).
10 This option sets the interval
seconds
between Call Waiting tones.
This timer also sets the interval
between Off-Hook Signaling
alerts.
10
seconds
10
seconds
0 After a call is interrupted (such
seconds
as Barge In, Voice Mail
Conversation Recording, Voice
Over, etc), the system repeats
the Intrusion Tone after this
interval. Normally, you should
enter 0 to disable this interval.
0
seconds
60
seconds
Document Revision 1
Related
Description
Program
14-01-18
2 - 185