Single Line Telephone Basic Data Setup - NEC Electra Elite IPK II Programming Manual

Electra Elite IPK II
Level:
IN
Description
Use Program 15-03 : Single Line Telephone Basic Data Setup to set up various
single line telephone options.
Input Data
Item
No
01
02
03
04
05
Electra Elite IPK II Programming Manual
Program 15 : Extension, Basic Setup

15-03 : Single Line Telephone Basic Data Setup

Extension Number
Item
SLT Signaling Type
Use this option to tell the system the type of
dialing the connected telephone uses.
In order for the Electra Elite IPK II Wireless
telephones to function correctly, this must be set
to '0' (dial pulse). If this option is set for DTMF,
after an outside call is placed, the system will not
dial any additional digits.
This program change is automatically performed
when the Electra Elite IPK II Wireless telephone
is registered when using system software 1.13+.
When upgrading software from prior versions,
the previous default of '1' will be saved from the
prior database so this option must be changed
manually.
--- Not Used ---
Terminal Type
Enter 1 for this option to allow a single line port
to receive DTMF tones after the initial call setup.
Enter 0 to have the port ignore DTMF tones after
the initial call setup. For Voice Mail, always enter
1 (e.g., receive DTMF tones).
Flashing
Enables/disables Flash for single line (500/2500
type) telephones.
Trunk Polarity Reverse
Not Used in U.S. - Do Not Change Default Entry as
DTMF issues may arise with voice mail.
Document Revision 1
Maximum 8 digits
Input Data Default
0 = DP 1
1 = DTMF
0 = Normal 0
1 = Special
0 = No
1
1 = Yes
0 = Off 0
1 = On
Related
Program
2 - 113