NEC Electra Elite IPK II Programming Manual page 583

Document Revision 1
Alarm
10
11
12
13
2 - 548
TYPE Report
3 2 (MIN) 0
4 2 (MIN) 0
5 0 0
6 0 0
7 1 (Major) 0
8 1 (MAJ) 0
9 0 0
0 0
0 0
0 0
0 0
: : :
Is Used To
Note
Advise of . . .
Board Installation ETU was unplugged
Error without using the
proper procedure.
Communication ETU communication
Error Between failure has occurred.
Board and NTCPU
Download Error Download may have
failed because the ETU
is blocked (disabled) or
the sub-program does
not exist on the system
flash card.
-- Not Used --
Power Failure System power supply
may be defective or
commercial power is
off.
RAM Backup RAM backup battery on
Battery Error the CPRU ETU is
unplugged or defective.
Blocking (No Failure may have
Default Setting) occurred because:
Terminal blocking
H
detected.
Terminal is
H
unplugged.
Wire is
H
disconnected.
DSTU card is
H
defective.
ISDN
CTI
ACD
-- Not Used --
:
Program 90 : Maintenance Program
Electra Elite IPK II
Action
Check the ETU
installation.
Remove and reinstall
the ETU. If RECover
message is received
in the alarm report,
the ETU is good. If
not, replace with a
new ETU.
After unblocking the
ETU, if RECover
message is received
in the alarm report, it
is corrected. If not,
then replace the
system flash card.
Check the system AC
switch, fuse and AC
outlet. If still faulty,
replace the power
supply.
Check the battery
connector. If it is
connected correctly,
then replace the
battery.
Check the terminal
wiring and reconnect
properly. Then unplug
and plug in the ETU. If
RECover message is
received in the alarm
report, it is correct. If
not, replace the ETU
and/or
terminal.