Outputs For Signaling - Hitachi Relion 650 Series Technical Manual

1MRK 511 557-UEN Rev. A
Connector
X317
X317
X317
X317
Table 407: Power outputs on BIO (not used in PWC600 pre-configuration)
Connector
X326
X326
X326
15.3.2

Outputs for signaling

Outputs designated "SO" are relay contacts designed for indicating configurable conditions in the
application.
Connectors are delivered with the device. Each connector terminal is connected with one 0.5...2.5
mm² (AWG 20...13) wire or with two 0.5...1.0 mm² (AWG 20...17) wires.
Table 408: Signaling outputs on PSM
Connector
X317
X317
X317
Table 409: Signaling outputs on BIO
Connector
X326
X326
X326
X326
Table continues on next page
Technical Manual
Pin Description
Power output 3,
normally open (TCS)
5 –
6 +
7 Power output 4,
8 normally open
9 Power output 5,
10 normally open
11 Power output 6,
12 normally open
Pin Description
1 Power output 1,
2 normally open
3 Power output 2,
4 normally open
5 Power output 3,
6 normally open
Pin Description
13 Signal output 1,
14 normally open
15 Signal output 2,
16 normally open
17 Signal output 3,
18 normally open
Pin Description
7 Signal output 1,
8 normally open
9 Signal output 2,
10 normally open
11 Signal output 3,
12 normally open
13 Signal output 4,
normally open
© 2021 Hitachi Energy. All rights reserved.
IED physical connections
PCM600 Info
Hardware module Hardware channel
PSM_102 BO3_PO_TCS
PSM_102 BO4_PO
PSM_102 BO5_PO
PSM_102 BO6_PO
PCM600 Info
Hardware module Hardware channel
BIO_4 BO1_PO
BIO_4 BO2_PO
BIO_4 BO3_PO
GUID-B6501A9C-D431-4FD9-9DBC-3A470F85F1E5 v1
PCM600 Info
Hardware module Hardware channel
PSM_102 BO7_SO
PSM_102 BO8_SO
PSM_102 BO9_SO
PCM600 Info
Hardware module Hardware channel
BIO_4 BO4_SO
BIO_4 BO5_SO
BIO_4 BO6_SO
BIO_4 BO7_SO
Section 15
423