Mitsubishi Electric GT1685 Connection Manual page 323

(3) Routing parameter setting
Up to 64 [Transfer Network No.]s can be set.
However, the same transfer network number cannot be
set twice or more (multiple times).
Therefore, the one that can access to other station from
the request source host GOT is 64 kinds of [Transfer
Network No.]s.
Item
Target network No.
Relay network No.
Relay station No.
POINT POINT POINT
Routing parameter setting of request source
Routing parameter setting is also necessary for the
request source GOT.
For the setting, refer to the following.
8.3.4 Routing parameter setting
(4) Communication confirmation
The INIT. LED on the Ethernet module turns on when
the module is ready to communicate.
For confirming the communication state, refer to the
following.
■Confirming the communication state of
Ethernet module
QJ71E71-100
RUN ERR.
INIT. COM.ERR.
OPEN 100M
SD RD
*1 The LEDs layout of QJ71E71-100.
Range
1 to 239
1 to239
1 to 64
*1

[Controller Setting] and [Ethernet] of GT
Designer3
(1) Controller setting
Item
GOT NET No.
GOT PLC No.
GOT IP Address
GOT Port No.
(Communication)
GOT Port No.
(Ethernet Download)
Default Gateway
Subnet Mask
Retry
Startup Time
Timeout Time
Delay Time
(2) Ethernet setting
Item
Host
N/W No.
PLC No.
Ethernet
Type
setting No.1
IP address
Port No.
Communication
POINT POINT POINT
[Controller Setting] and [Ethernet] of GT Designer3
For [Controller Setting]
Designer3, refer to the following.
8.3.1 Setting communication interface
(Communication settings)
8. ETHERNET CONNECTION
8.4 PLC Side Setting
Set value (Use default value)
1
1
192.168.0.18
5001
5014
0.0.0.0
255.255.255.0
3times
3sec
3sec
0ms
Set value
*
1
2
QJ71E71
192.168.0.19
5001 (fixed)
UDP (fixed)
and [Ethernet] of GT
8 - 37
1
2
3
4
5
6
7
8