Parameter Setting (When Connecting To C Controller Module (Q Series)) - Mitsubishi Electric GT1685 Connection Manual

(2) Station information setting
*1
Item
*2
Station type
Number of stations
Exclusive station 1 (fixed)
occupied
Reserve/invalid station
select
Intelligent buffer select
(Use default value)
(word)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)] or [Remote net - Additional mode], set to
[Ver. 1 Intelligent device station].
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU ether turning OFF and then ON
or resetting.
(3) Completion confirmation
After initial communications of CC-Link are completed,
the L RUN LED of AJ65BT-G4-S3 turns on.
The GOT starts to monitor after the L-RUN LED of
AJ65BT-G4-S3 turns on.
It does not monitor while the L RUN LED turns off.
PW
RUN
L RUN
SD
RD
L ERR.
14 - 16
14. CC-Link CONNECTION (Via G4)
14.5 PLC Side Settings
Setting necessity
Set value
at GOT connection
Intelligent device
station (fixed)
No setting
: As necessary : Not necessary
14.5.5 Parameter setting (when
connecting to C Controller
module (Q Series))
Use SW3PVC-CCPU-E Ver.3.05F or later for the C
Controller module setting utility.
(1) Connection settings
Item
*1
Target module
Write authority
*2
User name
*2
Password
Detailed settings
: Necessary
*1 If the IP address of the C Controller module (Q Series) has
been changed, input the changed IP address or host name.
*2 If the account of the C Controller module (Q Series) has
been changed, input the changed user name and password.
Setting
necessity
Set value
at GOT
connection
192.168.3.3
Mark the checkbox
target
password
-
: As necessary : Not necessary