Mitsubishi Electric GT1685 Connection Manual page 457

Item Set value
Station No. 0 (fixed)
*1
156kbps
Transmission speed
Parameter setting Engineering tool
: Necessary
*1 Adjust the settings with GOT settings.
(b) Link refresh setting
Item
Special relay (SB) refresh
device
Special register (SW)
refresh device
Remote input (RX) refresh
device
Remote output (RY) refresh
Set as necessary.
device
Remote register (RWr)
refresh device
: Necessary
Setting necessity
at GOT
connection
: As necessary : Not necessary
Setting
necessity at
Set value
GOT
connection
-
-
: As necessary : Not necessary
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
(c) CC-Link configuration setting
*1
Item
Ver.2 Intelligent device
Station type
*2
Expanded cyclic setting
*2
Exclusive station count
Remote station points
Reserve/invalid station select
Intelligent buffer select (word) (Use default value)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the unit parameter
After writing unit parameters to the PLC CPU, turn the
PLC CPU OFF then back ON again, or reset the PLC
CPU.

[Communication settings] of GT Designer3
Item
Station No.
Transmission Rate
Mode
Expanded Cyclic
Number of stations occupied
Input for Error Station
Retry
Timeout Time
Delay Time
POINT POINT POINT
[Controller Setting] of GT Designer3
For the setting method of [Controller Setting] of GT
Designer3, refer to the following.
13.3.1 Setting communication interface
(Communication settings)
13.4 PLC Side Setting
Setting
necessity at
Set value
GOT
connection
station (fixed)
Single
Exclusive station 1
32 points (fixed)
No setting
: As necessary : Not necessary
Set value
1: Station No.1
0: Online 156kbps
Ver.2: Remote net (Ver.2 mode)
Single
1 Station
0: Clear
3times (Use default value)
3sec (Use default value)
0sec (Use default value)
13 - 17
9
10
11
12
13
14
15
16