Mitsubishi Electric GT1685 Connection Manual page 470


Parameter setting (when connecting to
MELSEC-Q or QS series)
(1) [Network parameter] of GX Developer
(a) Network parameter
Item
No. of boards in module
*1
Start I/O No.
Operation setting
Type
Mode
All connect count
Remote input (RX)
Remote output (RY)
Remote register (RWr)
Remote register (RWw)
Special relay (SB)
Special register (SW)
Retry count
Automatic reconnection
station count
Stand by master station No.
PLC down select
Scan mode setting
Delay information setting
Station information setting
Remote device station initial
setting
Interrupt setting
: Necessary
*1 When using Q170MCPU, set it according to the system
configuration.
13 - 30
13. CC-Link CONNECTION (INTELLIGENT DEVICE STATION)
13.4 PLC Side Setting
Setting
necessity at
Set value
GOT
connection
1
0000
H
(Use default value)
Master station (fixed)
Remote net
(Ver.2 mode)
2
X400
Y400
D300
D200
SB0
SW0
(Use default value)
Refer to (b)
(Use default value)
: As necessary : Not necessary
(b) Station information setting
• Station information setting of station No.1 (GOT)
*1
Item
Station type
*2
Exclusive station count
Reserve/invalid station
select
Intelligent buffer select
(word)
: Necessary
• Station information setting of station No.2 (GOT)
*1
Item
Station type
*2
Expanded cyclic setting
*2
Exclusive station count
Reserve/invalid station
select
Intelligent buffer select
(word)
: Necessary
*1 When the [Mode] of the CC-Link module is set at [Remote
net - (Ver. 2 mode)], [Remote station points] can be set.
[Remote station points] is a setting for the remote I/O station.
The default value (32 points) must be used on the GOT.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the PLC CPU,
operate the PLC CPU ether turning OFF and then ON
or resetting.
Setting
necessity at
Set value
GOT
connection
Ver.1 intelligent
device station (fixed)
Exclusive station 1
No setting
(Use default value)
: As necessary : Not necessary
Setting
necessity at
Set value
GOT
connection
Ver.2 intelligent device
station (fixed)
Single
Exclusive station 1
No setting
(Use default value)
: As necessary : Not necessary