Connecting To Ethernet Module (Fx Series) - Mitsubishi Electric GT1685 Connection Manual

8.4.11 Connecting to Ethernet
module (FX Series)
This section describes the settings of the GOT and
Ethernet module (FX Series) in the following case of the
system configuration.
POINT POINT POINT
Ethernet module (FX Series)
For details of the Ethernet module (FX Series), refer to
the following manual.
FX -ENET-L User's manual
3U
FX -ENET-ADP User's manual
3U

System configuration
■ [Controller Setting] and [Ethernet] of GT
Designer3
<Ethernet module> (The settings other than the
following are set to the default)
Network No.
PC No.
IP address
Port No.
Communication
format
■ Ethernet parameter settings of FX3U-ENET-L Configuration tool
*1 These setting items do not exist at the PLC side. However,
the virtual values must be set on the GOT side.
■
[Controller Setting] and [Ethernet] of GT
Designer3
<GOT>
(The settings other than the
following are set to the default)
PLC No. : 1
IP address : 192.168.0.18
Port No. : 5019
Communication : TCP (fixed)
format
*1
: 1 (virtual)
*1
: 2 (virtual)
: 192.168.0.19
: 5551
: TCP (fixed)

Ethernet parameter settings of FX3U-
ENET-L Configuration tool
(1) Ethernet settings
Set the Ethernet parameter with FX
Configuration tool.
For using FX3U-ENET-L Configuration tool, install GX
Developer Ver. 8.88S or later on the personal computer.
For details on FX3U-ENET-L Configuration tool, refer to
the following manual.
FX3U-ENET-L Configuration tool Operation
manual
Item Setting
Module
Module 0
Operational settings Refer to (2)
Initial settings (Use default value.)
Open settings Refer to (3)
Router relay parameter
(Use default value.)
E-mail settings
:Required
*1 Set the number of the Ethernet module.
8. ETHERNET CONNECTION
8.4 PLC Side Setting
-ENET-L
3U
Setting
(with GOT connected)
*1
:Set if necessary :Not required
8 - 49
1
2
3
4
5
6
7
8