Controller Setting] Of Gt Designer3 - Mitsubishi Electric GT1685 Connection Manual

(2) [Parameter Setting] of CC-Link utility
(a) Network parameter
Item
Number of modules
Target module
Start I/O No.
Channel No.
type
*1
Mode
Expanded cyclic
station
Operation
Occupied number
setting
Error event : input data
status
CPU stop: data link
status
Other settings
All connect count
Ver.1 Intelligent device
Station type
Expanded cyclic
station
Station
*2
information
Occupied number
settings
Remote station points
Reserve/invalid station
select
Intelligent buffer select
(word)
: Necessary
*1 If the CC-Link module [Mode] is [Remote net -Ver.1 mode],
[Remote station points] cannot be set.
*2 Set the same setting as that of the GOT.
POINT POINT POINT
When changing the network parameter
After writing the network parameter to the C Controller
module (Q Series), either turn the C Controller module
(Q Series) OFF and then ON or reset it.
Setting
necessity
Set value
at GOT
connection
1
1
0000
H
(Use default value)
Master station(fixed)
Remote net
(Ver.1 mode)
Single(fixed)
Exclusive station 1
(fixed)
Clear
Refresh
(Use default value)
1
station(fixed)
Single
Exclusive station 1
32 points
No setting
(Use default value)
: As necessary : Not necessary
14.5.6 [Controller Setting] of GT
Designer3
Item
Transmission Speed
Retry Count
Timeout Time
Delay Time
POINT POINT POINT

[Controller Setting] of GT Designer3

For [Controller Setting], of GT Designer3, refer to the
following.
14.4.1 Setting communication interface
(Communication settings)
14. CC-Link CONNECTION (Via G4)
14.5 PLC Side Settings
9
Set value
9600bps
19200bps
10
38400bps
57600bps
115200bps
0 to 5times
3 to 30sec
0 to 300ms
11
12
13
14
15
16
14 - 17