Functions - Epson RC180 Manual

Setup & Operation 2. Part Names and Functions

2.2 Functions

(1) -1 Fan Filter (Without Option Unit)
(1) -2 Fan Filter (With Option Unit)
(2) LED
(3) Seven-segment LED
(4) Signature label (top panel)
(5) MT label (top panel)
(6) Controller Number label
(7) M/C POWER connector
(8) Connection Check label
14
A protective filter is installed in front of the fan to filter out dust.
Check the condition of the filter regularly and clean it when necessary. A dirty filter
may result in malfunction of the robot system due to temperature rise of the
Controller.
For inspection, cleaning, and replacement, refer to the Maintenance 6.1 Fan and Fan
Filter.
A protective filter is installed in front of the fan to filter out dust.
Check the condition of the filter regularly and clean it when necessary. A dirty filter
may result in malfunction of the robot system due to temperature rise of the
Controller.
For inspection, cleaning, and replacement, refer to the Maintenance 6.1 Fan and Fan
Filter.
The LED indicates current operation mode (TEACH, AUTO, or PROGRAM mode).
For details, refer to Setup & Operation 2.3 LED and Seven-segment LED.
Four-digit seven-segment LED displays the line number and the status of the
controller (error number, warning number, status of Emergency Stop and Safety
Door).
For details, refer to Setup & Operation 2.3 LED and Seven-segment LED.
The serial number of the Controller and other information are shown.
The label indicates the specification number for the customized Manipulator and is
attached only to the customized Manipulator. If your Manipulator indicates this
label, it may require a specific maintenance procedure. In this case, make sure to
contact your dealer before performing any maintenance procedures.
The serial number of the Controller is indicated.
A connector for the Manipulator power source.
Connect the dedicated power cable attached to the Manipulator.
The details of the Manipulator to be connected are recorded on
the label as shown in the right.
Manipulator model and Manipulator serial number.
The label indicates the
MANIPULATOR
G6-551S 00002
RC180 Rev.17