Installation - Epson RC180 Manual

Setup & Operation 3. Installation

3.2.2 Installation

- Mount the Controller mounting screws with 80 to 110 Ncm torque.
- Install the controller on a flat surface such as wall, floor, and controller box in the
direction shown from (A) to (D).
(A)
(C)
There are two types of fixtures. Mount the fixture to the Controller with the four
attached screws.
The length from the edge of fixture L differs by the side. Refer to the following figure
NOTE

and mount the side with shorter distance from the edge to the screw hole on the Upper
side.
22
Base Table
Fixture L: Used in (A), (B), and (D)
Fixture S: Used in I
(B)
Fixture L
(D)
Fixture S
Base Table
Fixture L
Rack
Fixture L
Base Table
RC180 Rev.17