Epson RC180 Manual page 186

Maintenance 8. Trouble Shooting
No. Message
Cannot execute in Remote Ethernet
1037 enable except
Ethernet.
Cannot execute in Remote RS232C
1040 enable except
RS232C.
Cannot execute during Emergency
1041
Stop status.
Cannot execute while the safeguard is
1042
open.
1043 Cannot execute during error condition.
Cannot execute when the remote pause
1044
input is ON.
Input waiting condition is the only
1045
available condition to input.
1046 Cannot execute during file transfer.
Cannot cancel the command executed
1047
from other devices.
Cannot execute after after low voltage
1048
was detected.
1049 Other devices are in program mode.
1050 Password is too long.
1051 Export Controller Status failed.
1052 Export Controller Status busy.
1100 File failure. Cannot access the file.
File failure. Read and write failure of
1102
the registry
1103 File is not found.
1104 Project file was not found.
1105 Object file was not found.
1106 Point files were not found.
The program is using a feature that is
1107 not supported by the current controller
firmware version.
One or more source files are updated.
1108
Please build the project.
1109 Not enough storage capacity.
1110 File is not found.
1120 File failure. Setting file is corrupt.
1121 File failure. Project file is corrupt.
1122 File failure. Point file is corrupt.
1123 File failure. I/O label file is corrupt.
File failure.
1124
User error file is corrupt.
174
The command cannot be executed by the
from the Remote console except the remote Ethernet when
Auto flag of the remote Ethernet is ON.
from the Remote
Cancel the Emergency Stop status.
Close the safeguard.
Cancel the error condition.
Change the remote pause input to OFF.
The controller received an input while it
was not in the Input waiting condition.
Execute after the file transmission.
Cancel the motion command from the
device the command was issued from.
Reboot the controller.
Enter the password that is less than 16
characters.
1. Retry using the same USB
2. Retry using another USB
3. Retry after rebooting the
Execute the command after completing
the controller status backup.
1. Reboot the controller.
2. Reinstall the firmware.
3. Replace the CF.
1. Reboot the controller..
2. Replace the CF.
Check whether the file exists.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Increase free space of the USB memory.
Restore the controller configuration.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Rebuild the project.
Remedy
memory.
memory.
controller.
Note 1 Note 2
RC180 Rev.17