Epson RC180 Manual page 207

No. Message
Cannot execute
2385
executing GoSub.
EResume was used without OnErr.
2386
Review the program.
Curve failure. Failed to open the Curve
2400
file.
Curve failure. Failed to allocate the
2401
header data of the curve file.
Curve failure. Failed to write the curve
2402
file.
Curve failure. Failed to open the curve
2403
file.
Curve failure. Failed to update the
2404
curve file.
Curve failure. Failed to read the curve
2405
file.
2406 Curve failure. Curve file is corrupt.
Curve failure. Specified a file other
2407
than the curve file.
Curve failure. Version of the curve file
2408
is invalid.
Curve failure. Robot number in the
2409
curve file is invalid.
Curve failure. Cannot allocate enough
2410
memory for the CVMove statement.
Specified point data in the Curve
2411 statement is beyond the maximum
count.
Specified number of output commands
2412 in the Curve statement is beyond the
maximum count.
Curve failure. Specified internal code
2413 is beyond the allowable size in Curve
statement.
Specified continue point data P(:) is
2414
beyond the maximum count.
Curve failure.
2415
Cannot create the curve file.
2416 Curve file does not exist.
Curve failure. Output command is
2417
specified before the point data.
2418 Curve file name is too long.
Curve failure.
2419
Curve file path is too long.
2420 Curve file name is invalid.
Error message failure. Error message
2430
file does not exist.
RC180 Rev.17
EResume while
Review the program.
Review the program.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
Create a Curve file again.
Reboot the controller.
The
specified in the Curve statement is 200.
Review the program.
The
commands
statement is 16. Review the program.
Reboot the controller.
The
specified continuously is 200. Review
the program.
Reboot the controller.
Create a Curve file again.
Check whether the specified Curve file
name is correct.
Check whether no output command is
specified before the point data.
Check whether the specified Curve file
name is correct. The maximum string
length of the file name is 32.
Check whether the specified Curve file
name is correct.
Reboot the controller.
Maintenance 8. Trouble Shooting
Remedy
maximum number of
maximum number of
specified in the
maximum number of
Note 1
points
output
Curve
points
Start point End point
Note 2
195