ABB REC 561 User Manual page 374

ABB Network Partner AB
Version 1.0-00
Apparatus control
Table 15: Input signals for SWICONA
IN:
SAxx-SY_FAIL
SAxx-SY_OK
SAxx-AR_SEL
Table 16: Output signals for SWICONA
OUT:
SAxx-OX
SAxx-CX
SAxx-POS_ERR
SAxx-POL_DISC
SAxx-MA_UPD_P
SAxx-SEL_OPEN
SAxx-SEL_CLOS
SAxx-EXE_OPEN
SAxx-EXE_CLOS
SAxx-SEL_RES
SAxx-SEL_ERR
SAxx-CMD_ERR
1MRK 580 150-XEN
DESCRIPTION:
To be set to true when the synchro-check
fails and the command execution will stop
Closing will be permitted at set to true by the
synchro-check and when SY_RUN is true
Selection input for fast autoreclosing. It is
used only with external selection relays
DESCRIPTION:
Indication that the apparatus is in open posi-
tion. Result of the three single phase indica-
tions or blocking of the process updating or
by the manually entered open position
Indication that the apparatus is in close
position. Result of the three single phase
indications or blocking of the process updat-
ing or by the manually entered close posi-
tion
Position error. Result of that at least one of
following conditions are fulfilled: One phase
is both open and closed, one phase is in
middle position longer than T_POSERR, the
input POSIND_V is false
Output indicating pole discordance, after
that the time T_POL has elapsed
Output indicating manual control of position
updating
Selection output for open direction
Selection output for close direction
Execute output for open direction (settable
pulse length)
Execute output for close direction (settable
pulse length)
Reset the selection after successful or failed
operation (pulse output)
Output indicating a failure in the selection, if
no feedback select signal FDB_SEL is acti-
vated before the time T_SEL has elapsed
Output indicating a command error. That is
done if the position indication of the exe-
cuted apparatus does not indicate a start in
the position change before the time
T_START has elapsed
Page 6 - 89