Settings, Introduction - ABB REC 561 User Manual

ABB Network Partner AB
Version 1.0-00
October 1996
Function:

1 Settings, introduction

Disturbance report - Settings
Basic
The main part of the settings for the Disturbance Report is found on the
built-in, man-machine interface (MMI) at:
Settings
DisturbReport
The settings include:
Operation
RecordingTimes
BinarySignals
AnalogSignals
FaultLocator
User-defined names of analogue signals can be set at:
Configuration
AnalogInputs
The user-defined names of binary signals can be set at:
Configuration
DisturbReport
The analogue and binary signals appear with their user-defined names.
An additional setting is found at:
Service Report
DisturbReport
This parameter can be read and set:
SequenceNo
Disturbance Report (On/Off)
Recording times for the Disturbance Recorder and
the event/indication logging, including pre-fault
time, post-fault time, and limit time for the entire
disturbance
Selection of binary signals, trig conditions and
MMI indication mask
Recording mask and trig conditions
Filter time and distance measurement unit (km/
miles/%)
Input n (1-48)
Sequence number (0-255) (normally not necessary
to set)
1MRK 580 133-XEN
Page 7 - 57