ABB REC 561 User Manual page 377

1MRK 580 150-XEN
Page 6 - 92
Apparatus control
Table 17: Input signals for SWICONB
IN:
SBxx-SY_RUN
SBxx-SY_FAIL
SBxx-AR_SEL
Table 18: Output signals for SWICONB
OUT:
SBxx-OX
SBxx-CX
SBxx-POS_ERR
SBxx-POL_DISC
SBxx-MA_UPD_P
SBxx-SEL_OPEN
SBxx-SEL_CLOS
SBxx-EXE_OPEN
SBxx-EXE_CLOS
SBxx-SEL_RES
SBxx-SEL_ERR
SBxx-CMD_ERR
ABB Network Partner AB
DESCRIPTION:
Connected to the synchro-check module
(equipment). At true all timers in SWICONB
are stopped
To be set to true when the synchro-check
fails and the command execution will stop
Selection input for fast autoreclosing. It is
used only with external selection relays
DESCRIPTION:
Indication that the apparatus is in open posi-
tion. Result of the three single phase indica-
tions or blocking of the process updating or
by the manually entered open position
Indication that the apparatus is in close
position. Result of the three single phase
indications or blocking of the process updat-
ing or by the manually entered close posi-
tion
Position error. Result of that at least one of
following conditions are fulfilled: One phase
is both open and closed, one phase is in
middle position longer than T_POSERR, the
input POSIND_V is false
Output indicating pole discordance, after
that the time T_POL has elapsed
Output indicating manual control of position
updating
Selection output for open direction
Selection output for close direction
Execute output for open direction (settable
pulse length)
Execute output for close direction (settable
pulse length)
Reset the selection after successful or failed
operation (pulse output)
Output indicating a failure in the selection, if
no feedback select signal FDB_SEL is acti-
vated before the time T_SEL has elapsed
Output indicating a command error. That is
done if the position indication of the exe-
cuted apparatus does not indicate a start in
the position change before the time
T_START has elapsed
Version 1.0-00