Figure 86 Install Cable Securing Clamps At The Ilp - HP Indigo Division Series Instruction For Use & Installation Instructions

Cable

Figure 86 Install cable securing clamps at the ILP

1 Rear inner ILP
2 Cables from ILP assemblies to cabinet M1
and PE1
3 Clamp rail
4. Install the cable securing clamps on the clamp rail as shown in Figure 86:
a. Arrange the cables according to the cable securing panel labels shown in Figure 86.
b. Mount securing clamps on each cable to secure the cable in position.
end point
ILP
Inlet hose from air valve
at wall.
Outlet hose to unwinder
4 Securing clamps
5 ILP rear panel
6 Cable labels
CA294-03070 rev 00
Origination point
Main compressor pump outlet.
ILP compressor pump.
Installation Manual
Notes
page 106 of 153