Figure 76 Aligning The Ilp Feed Stepping Plate Rollers - HP Indigo Division Series Instruction For Use & Installation Instructions

b. Place the Parallel jig (P/N CA045-07192) between the PE1 drive roller and the ILP
Idler No. 10 (Figure 75).
c. Move the Parallel jig from front (of press) to rear and back to front (Figure 75).
Make sure that the difference in distance between PE1 and ILP at both the front and
rear of the press, between the parallel jig readings is 0.00 ±0.01 mm.

Figure 76 Aligning the ILP feed stepping plate rollers

1 Allen M5 rear adjustment screw
2 Allen M5 rear adjustment bracket locking screw
3 Stepping plate roller (to be aligned)
4 Gauge bracket
5 Allen M5 front adjustment screw
12. To level and align the ILP exit stepping plate rollers (Figure 76):
For each roller
a. Place a leveler on the roller and verify that the roller is level at the front and rear.
b. Reconfigure the parallel jig for the intermediate configuration. Refer to the section
General information on page 17.
c. Place the Parallel jig between the PE1 input idler No. 2 and the roller shown in
Figure 76.
Make sure that the gauge bracket is orientated as shown in Figure 76.
d. Loosen the Allen M5 front and rear adjustment bracket locking screws.
e. Adjust the Allen M5 front and rear adjustment screws and move the Parallel jig from
front to back to accurately align the roller.
Make sure that the rollers are aligned to an accuracy of 0.00 ± 0.01 mm.
If the difference between the readings is more than 0.00 ± 0.01 mm, turn the
adjustment screw on the front mount of the roller to correct the alignment.
6
7
8
9
10
CA294-03070 rev 00
Allen M5 front adjustment bracket locking
screw
Parallel jig
ILP exit stepping plate rollers
PE1
PE1 input idler No. 2
Installation Manual
page 94 of 153