HP Indigo Division Series Instruction For Use & Installation Instructions page 14

Heading Step Reference Procedure
8. Verify the writing head focus.
9. Verify the accuracy of the front to
back and side to side prints:
a. Perform the natural web length
calibration for duplex. See HP
Indigo Service Instruction
Calibrations,
MNU-1633-01.
b. Perform the eye mark sensor
vertical positioning. See HP
Indigo Service Instruction
Calibrations, MNU-1633-01.
c. Perform the eye mark sensor
lateral positioning. See HP Indigo
Service Instruction Calibrations,
MNU-1633-01.
d. Perform the eye mark distance to
nip adjustment. See HP Indigo
Service Instruction Calibrations,
MNU-1633-01.
e. Make sure that the substrate is
centered at PE1. Print and check.
f. Make sure that the substrate is
centered at PE2. Print and check.
10. Perform color adjustment using the
paper roll supplied with the press.
If a different substrate is to be
installed on the press, perform the
following:
a. Load glossy paper on the press.
b. From the Adjustments menu,
click Color Adjustment &
Calibration.
The Color Adjustment Wizard
Manager window opens.
c. In the Automatic Color
Adjustment area, click Custom
Color Adjustment.
The Custom Color Adjustment
wizard opens.
d. Select the desired matrix.
e. In the Electrode Voltage
Calibration field, select Include
Velectrode Calibration.
f. Click Next. The OD step opens.
g. In the Select Method of Substrate
OD Usage field, select Read
Substrate OD.
CA294-03070 rev 00
Installation Manual
Notes and
check
page 14 of 153