HP Indigo Division Series Instruction For Use & Installation Instructions page 12

Heading Step Reference
54. Connect on page 108
55. Install the ILP rear
panel safety cover on
page 111
56. Install the ILP
vacuum hoses on
page 112
57. Installing the ink
cabinets on page 113
Ink cabinets
(90 mins)
58. Place on page 116
59. Adjusting the web
guide on page 116
Web guide
(10 mins)
60. Install the utility
cabinet on page 117
Utility
cabinets
(20 mins)
61. Connect the
computers on page
121
Computers
installation
(40 mins) 62. Install the computer
cables on page 126
63. Install the master
console on page 127
Procedure
Connect the following air hoses at the ILP
front:
Input hose from mains air supply to
Inlet connection.
Long outlet hose from Outlet to PE
connection to PE1.
Long outlet hose from Outlet to UW
connection to unwinder.
Install safety cover at the ILP front.
Connect the vacuum hose to the ILP.
Install each ink cabinet according to color
order shown in Figure 93 on page 113 for
four colors, and Figure 94 on page 113 for
seven colors.
If more than four colors to be installed,
make sure that relevant calibration kit is
ordered for extra colors.
Mount and install the corian working
surface.
Mount the monitor, keyboard and mouse
on working surface.
Remove the two securing screws and
adjust the web guide.
Customer to save screws.
To troubleshoot, refer to w3200 service
manual Calibrations.
Install the utility cabinets and connect
hoses from utility cabinets to the printing
engines.
Cooling water in
Cooling water out
Solid add compressed air
Impression drum cooling drain
Vacuum
Air flow
Connect control cable and power cable to
utility cabinets.
Check the network diagrams in Figure 102,
Figure 103, and Figure 104 on page 121 -
122.
Install Slaves 1 and 2 computers in
electrical cabinet M2.
Install the computer cables to both slave
computers.
Install master console, and connections to
master computer.
CA294-03070 rev 00
Installation Manual
Notes and
check
page 12 of 153