Figure 47 The Unidrive Unit - HP Indigo Division Series Instruction For Use & Installation Instructions

Figure 47 The Unidrive unit

1 CTNET connection
2 Encoder connection
NOTE:
8. Install all Unidrive cables as follows:
a. Remove the front lower covers from the Unidrives, and insert the following
connections (see Figure 46 and Figure 47):
For both printing engines, there are two 8 mm power and encoder motor cables.
b. Install the PE1-to-Unidrive cables as follows:
Cable From end point PE1
CC418 Drive motor, encoder connection
CC419 Motor drive power connector orange cable
CC420 Impression engage motor encoder
CC421 Motor drive power connector blue cable
PUBLISHER-1133
UD51 second encoder feedback module is not installed on all
Unidrives. In addition, the connector to the UD51 second
encoder feedback module is not installed on all Unidrives.
CA294-03070 rev 00
Installation Manual
1
2
To end point
FP1 encoder at 24U0
FP1 drive at 24K9, pins 2,4,6, PE, PE
IP1 encoder at 25U0
IP1 drive at 25K9, pins 2,4,6, PE, PE
page 66 of 153