Figure 70 Unlocking The Ilp Alignment Plates - HP Indigo Division Series Instruction For Use & Installation Instructions

At the ILP exit stepping plate assembly
5. Adjust the stepping plate gas spring arm so that the plate lifts without touching the ILP exit
side (Figure 64).

Figure 70 Unlocking the ILP alignment plates

1
1 Alignment plate locking screws (x6)
6. Open the front and rear ILP doors.
7. Release (do not remove) the six ILP alignment plate locking screws (Figure 70).
8. Lower the four ILP feet until the castors are approximately 5 mm above the floor platform and
the feet touch the floor.
CA294-03070 rev 00
Installation Manual
1
page 88 of 153