HP Indigo Division Series Instruction For Use & Installation Instructions page 15

Heading Step Reference Procedure
h. Click Next and Print.
The color adjustment is
performed.
Make sure that the wizard
completes all of its steps, and that
all colors pass the color adjust
procedure.
i. Click Finish.
j. Load the desired substrate on the
press.
k. Print the CATP job.
l. In the 9th and 10th copy of the
CATP printout, measure the solid
patches (J area), and calculate
the average values.
Note the values.
m. Change the press software to
technician mode.
n. From the Options menu, click
Systab Editor.
The Systab editor window opens.
o. Expand the mmiCATopic tree.
p. In the right window, double-click
SpecOdLowerDeltaOsm.
The mmiCATopic
SpecOdLowerDeltaOsm window
opens.
q. In the Saved field, type -0.7.
r. Click OK. The window closes.
s. Double-click
SpecOdLowerDelta5.
The mmiCATopic
SpecOdLowerDelta5 window
opens.
t. In the Saved field, type -0.7.
u. Click OK. The window closes.
v. Close the Systab Editor.
w. From the Adjustments menu,
click Color Adjustment &
Calibration.
The Color Adjustment Wizard
Manager window opens.
x. In the Automatic Color
Adjustment area, click Custom
Color Adjustment.
The Custom Color Adjustment
wizard opens.
y. In the Electrode Voltage
Calibration field, make sure that
Include Velectrode Calibration is
not selected.
z. Click Next. The OD step opens.
CA294-03070 rev 00
Installation Manual
Notes and
check
page 15 of 153