Figure 23 Moving The Raised Engine To The U-Base - HP Indigo Division Series Instruction For Use & Installation Instructions

The Allen M10 height adjustment screw (Figure 21) should be facing towards the
outer sides of the press for easy access.
l. Make sure that the leveling pads are at their default height (Figure 21-4).
If not use an Allen M10 key to lower or raise the height adjustment wedges to their
default level (Figure 21).

Figure 23 Moving the raised engine to the u-base

1 Front lifting frame
2 U-base
3 Leveling pads
4 Direction of lifting jig and engine over u-base
CA294-03070 rev 00
Installation Manual
page 39 of 153