HP Indigo Division Series Instruction For Use & Installation Instructions page 96

j. Tighten the front and rear adjustment bracket locking screws (Figure 77).
13. Install the ILP feed stepping plate between the Unwinder position and the ILP as described in
step 2 on page 83.
14. Repeat step 4 on page 86 to align the ILP feed stepping plate rollers.
15. Repeat step 12 on page 94 to level the ILP feed stepping plate rollers.
Place the Parallel jig between the unwinder lower roller and the stepping plate rollers.
CA294-03070 rev 00
Installation Manual
page 96 of 153