Connecting The Master Computer; Figure 108 Installing The Monitor Base - HP Indigo Division Series Instruction For Use & Installation Instructions

Connecting the master computer

1. Connect the following cables to the computer (Figure 107):
Port
Keyboard
Mouse
COM1
COM2
Audio out
External LAN
Internal LAN
To Slave 1
Video Out (Monitor)
Profibus WHS communications
VCorn
Modem
To Slave 2
To Master
Power
2. Place the keyboard and mouse on the working surface.

Figure 108 Installing the monitor base

1 Install screws here
3. Using the screws provided, connect the monitor base to the monitor (Figure 108).
4.
Pass the keyboard and mouse cables down through the slot to the computer and connect the
cables to the computer.
5. Connect the power cable to the LCD monitor.
6. Pass the flat three-wire audio cable and the video cable down through the slot to the
computer and connect the cables to the computer.
Connect the cable to line out and the red cable to mic.
7. Make sure that the following cables to the 8-port Ethernet switchbox are connected:
CC64 RJ45 from PC1 switchbox J4 to J1
CC65 RJ45 from PC2 switchbox J4 to J2
Master console cable
CC52
CC53
RS232 cable- to UPS
N/A
CC50
CC70
N/A
CC60A
CC51
CA261-11140
N/A
CC69
CC61A
N/A
CA294-03070 rev 00
Installation Manual
Slave 1 cable Slave 2 cable
CC52 CC52
CC53 CC53
CC44 CC44
CC47 CC47
CC50 CC50
N/A N/A
W190 (to switch) W190 (to switch)
N/A N/A
CC51 CC51
N/A N/A
CC48 CC48
N/A N/A
N/A N/A
CC60A CC61A
1
page 128 of 153