Figure 43 Securing The Electrical Cabinet Cables - HP Indigo Division Series Instruction For Use & Installation Instructions

Figure 43 Securing the electrical cabinet cables

1 Cable mounts here
2 Support back-plate
3 Cable bracket
NOTE:
IMPORTANT:
PUB-485
Use the cable bracket (P/N MCC-0821-05) to secure the
electrical cabinet-to-electrical cabinet and printing engine-to-
electrical cabinet cables to the inner wall channel bracket
attached to the wall of the electrical cabinets. (Figure 43).
Use the support back plate to support the rear of the cable.
Insert the cable bracket at the front of the cable.
Where a cable consists of a number of wires, the
black wires are labeled 1, 2, 3, 4 etc. in white on the
wire at the insertion ends.
Some cables are labeled U, VV, WWW, XXXX
instead of 1, 2, 3, 4.
Wires should be inserted in the order labeled at the
connection point.
CA294-03070 rev 00
Installation Manual
1
2
3
page 59 of 153