Figure 12 Focusing The Surveying Tool On The Foresight Stand Target; Figure 13 Leveling The Surveying Tool - HP Indigo Division Series Instruction For Use & Installation Instructions

Figure 12 Focusing the surveying tool on the foresight stand target

1 2 3 4 5
0.5 mm
1 Height adjustment screws
2 Crosshair target
i. Position the surveying tool facing and parallel to the foresight stand (Figure 12).

Figure 13 Leveling the surveying tool

1 Level bubble
j. Adjust the level of the surveying tool until the bubble is centered in the level
(Figure 13).
k. Focus the surveying tool so that the cross target on the foresight is clearly seen and
centered with the crosshairs of the surveying tool (Figure 11).
If necessary, adjust the height of the cross target on the foresight stand.
1
2
1
PUB_1346
CA294-03070 rev 00
Installation Manual
1
page 30 of 153