Figure 71 Leveling And Aligning The Ilp - HP Indigo Division Series Instruction For Use & Installation Instructions

Figure 71 Leveling and aligning the ILP

15
14
13
12
11
10
9
8
1 ILP external frame
2 Feed pull screw (similar at exit)
3 Feed push screw (similar at exit)
4 ILP internal frame
5 ILP rear foot
6 ILP feed stepping plate assembly
7 ILP front foot
8 Height adjustment nut
NOTE:
9. To level and align the ILP (Figure 71):
At the lower ILP frame
a. Using an Allen M6 key, loosen the six frame securing screws shown in Figure 71.
This allows adjustments to the ILP internal and external frames.
7
9
10
11
12
13
14
15
There are two sets of push/pull screws (Figure 71). The
outside screws of each set are the push screws. The inside
screws are the pull screws. The ILP moves
forward/backward 1 mm for each turn of a screw.
CA294-03070 rev 00
W3250_ILD_ALIGNMENT_2971
Securing nut
ILP internal frame
ILP frame securing screw
ILP external frame
Position of ILP front frame securing screws
Position of ILP rear frame securing screws
ILP exit stepping plate assembly
Installation Manual
1
2
3
4
5
6
page 89 of 153