Figure 91 Installing The Safety Cover On The Ilp Rear Panel - HP Indigo Division Series Instruction For Use & Installation Instructions

c. Insert the air hose from the PE2 engine to the parallel outlet of the T-junction.
Route the hose to the PE2 air manifold.
d. Insert two short hoses to the v-junction adapter and route the hoses as follows:
To the input at the ILD dial regulator
To the PE1 air manifold rear input to the Web Guide
At the PE2 air manifold
4. Repeat step 3 above at the PE2 engine.
At the parallel outlet of the T-junction, insert a stopper.
5. Connect the unwinder air supply hose to the unwinder.

Figure 91 Installing the safety cover on the ILP rear panel

1 Securing screws
2 ILP rear panel safety cover
6. Install the ILP rear panel safety cover using two Allen M3 x 12 screws, washers and spring
washers (Figure 91).
3 Securing screws
CA294-03070 rev 00
Installation Manual
page 111 of 153