HP Indigo Division Series Instruction For Use & Installation Instructions page 144

The Color Adjustment Wizard Manager window opens.
c. In the Automatic Color Adjustment area, click Custom Color Adjustment.
The Custom Color Adjustment wizard opens.
d. Select the desired matrix.
e. In the Electrode Voltage Calibration field, select Include Velectrode Calibration.
f. Click Next. The OD step opens.
g. In the Select Method of Substrate OD Usage field, select Read Substrate OD.
h. Click Next and Print.
The color adjustment is performed.
Make sure that the wizard completes all of its steps, and that all colors pass the color
adjust procedure.
i. Click Finish.
j. Load the desired substrate on the press.
k. Print the CATP job.
l. In the 9th and 10th copy of the CATP printout, measure the solid patches (J area),
and calculate the average values.
Note the values.
m. Change the press software to technician mode.
n. From the Options menu, click Systab Editor.
The Systab editor window opens.
o. Expand the mmiCATopic tree.
p. In the right window, double-click SpecOdLowerDeltaOsm.
The mmiCATopic SpecOdLowerDeltaOsm window opens.
q. In the Saved field, type -0.7.
r. Click OK. The window closes.
s. Double-click SpecOdLowerDelta5.
The mmiCATopic SpecOdLowerDelta5 window opens.
t. In the Saved field, type -0.7.
u. Click OK. The window closes.
v. Close the Systab Editor.
w. From the Adjustments menu, click Color Adjustment & Calibration.
The Color Adjustment Wizard Manager window opens.
x. In the Automatic Color Adjustment area, click Custom Color Adjustment.
The Custom Color Adjustment wizard opens.
y. In the Electrode Voltage Calibration field, make sure that Include Velectrode
Calibration is not selected.
z. Click Next. The OD step opens.
aa. Click Setup.
The Setup OD of 100% Spec Values window opens.
CA294-03070 rev 00
Installation Manual
page 144 of 153