Information Center Installation - Philips M3150B Installation And Service Manual

Information
The final step is to install all Information Centers, Clients, and their peripheral equipment --
Center
displays, keyboards, mouses, video splitters, keyboard-video-mouse switches, recorders, etc.
Installation
in their planned locations. Rear panel cabling connections for Information Center
workstations are shown in Figure 5-11. Rear panel cables without screw connected plugs
must also be secured so they do not accidentally unplug. Figure 5-13 shows examples of
how to secure cables of friction fit plugs to cables with screw connected plugs using cable
ties.
Note Connect the speaker to the connector on the Audio Card with the speaker icon.
.
Voltage Select Switch
Power Cord Connector
Mouse Connector
Keyboard Connector
Warning Cables with plugs not firmly attached by screw connections must be secured to prevent
accidental unplugging. Make certain that the speaker cable cannot accidentally be
pulled out because it annunciates alarms. Use the Strain Relief Kit (M3150-60019)
provided and secure the speaker cable to another cable that is secured with a screw
connection. When securing all cables, be sure to provide strain relief loops and cinch
cable ties securely. See Figure 5-13.
Step 1. Install the 650 VA UPS with the proper voltage for the PC as follows:
(Optional) Hospital LAN NIC Card
Dual Video Card
(Optional)
Parallel Connector
First Serial Connector (COM A)
Figure 5-11 Rear Panel Connections to D510 Information Center PC
– Connect the battery wire of the 650 VA UPS.
– Turn Off the UPS On/Off switches.
– Connect the UPS input power cord to a properly grounded electrical output.
SDN Card
LAN Connector
Display Connector (not used if Dual Display)
Locating System Components
Sound Card
Second Serial
Connector (COM B)
-
10BT
100TX
Hardware Installation
5-11