Philips M3150B Installation And Service Manual page 419

Note Note: if you don't depress the F2 key during reboot cycle and remove the BIOS Upgrade
Disk, then the application will load and you will have to reboot the PC and try again.
Step 4. Press the Setup Defaults F9 key to open the Setup Defaults window, and press
Step 5. Select the Advanced menu in the Setup Utility by pressing the keyboard right
Step 6. Select Integrated USB Interface and verify it is set to Auto.
Step 7. Select Integrated Audio Interface and Change to Disabled.
Step 8. Select Video Options and press Enter. Select Video Primary Controller and
Step 9. Select Integrated I/O Ports:
Step 10. Select Boot Menu. Select Quick Boot Mode and Change to Disabled.
Step 11. Select Power Menu. Keep State after Power Failure at Auto. All other settings are
Remove the BIOS floppy disk and place it into the plastic holder on the side of the PC. And,
it is recommended that you make an additional copy of the BIOS (on another floppy disk)
and store the floppy disk in a safe and secure place.
Enter to continue.
arrow key.
• Select Plug & Play OS and verify it is set to Yes. (Set to No for Plug & Play OS if
prior to Release E.01)
Change to AGP or Embedded Video. Press Esc.
– Serial Port A
– Serial Port B
– Parallel Port
– Mode
– Press Esc.
disabled:
• Auto Suspend Timeout
• Suspend Wakeup On
– Modem Ring
– IRQ
– PCI Bus Activity
• Power Up On
– PCI Bus Activity
• Suspend to RAM
• Wakeup On Modem Ring
• Select F10 to SAVE and EXIT BIOS Setup
Change to Manual and Verify Settings: Base I/O 3F8;
Interrupt IRQ 4
Change to Manual and Change Settings:
Base I/O 2E8; Interrupt IRQ 3 (if no external modem)
Base I/O 2F8; Interrupt IRQ 3 (with external modem)
Auto (Default)
Change to ECP
Change to Disable
Change to Disable
Change to Disable
Change to Disable
Change to Disable
Change to Disable
Change to Disable
Maintenance, Troubleshooting, and Repair
Troubleshooting
7-133