Table of Contents
Advertisement
Network Names and IP Addresses
this window. Note that the default Subnet Mask and Default Gateway address are also
shown.
Setting Host
After all Network devices have been installed, their Host Names and IP Addresses should
Names and IP
be set. Philips workstations and the Server should have their Host Names changed to
Addresses
something associated with their setting or application. All Network devices -- Information
Centers, Clients, Server, Switches, Printers -- must also have their IP Addresses set before
Philips software can be installed and configured.
Notes
IP Addresses for M3/M4/IntelliVue Patient Monitors are automatically assigned by Philips
software.
Network Installation Worksheets are provided in Appendix A to record Host and
Device Names, hospital Locations, and IP Addresses. Complete these Network
Installation Worksheets for all devices on the Network.
Information
The following steps describe how to set Host Names and IP Addresses for Information
Centers, Clients,
Centers, Clients, and Small Database Servers. After these have been set, the Network
Patient Link, and
Interface Card (NIC) configuration must also be verified. That procedure follows.
Small Database
Step 1. Click on Start, Settings and Control Panel to open the Control Panel.
Server
Step 2. Double click on the System icon in the Control Panel window to open the
Step 3. Change the Computer Name for this device to a Host Name associated with its
5-36
Hardware Installation
Figure 5-34 IP Address from Control Panel on Windows XP/2000 Device
System Properties window of Figure 5-33.
location in the hospital, e.g. ICU, CCU.
Advertisement
Table of Contents
Troubleshooting
