Philips M3150B Installation And Service Manual page 420

Troubleshooting
Note The Kayak family of PCs are not supported with release E.01. The BIOS settings below are
listed for reference only, and they are for release E.0.
HP D6723T Kayak Step 1. Properly shutdown and restart the PC and IMMEDIATELY press and hold down
XA (Series 05xx)
or D6731T Kayak
Step 2. Select the Advanced menu in the Setup Utility by pressing the keyboard right
XA (Series 05)
Step 3. Select the ISA Resource Exclusion submenu by using the down arrow key and
Step 4. Select IRQ 3 and press Enter to access the IRQ3 submenu.
Step 5. Change the IRQ3 value to Reserved and press Enter. If a 4-Channel Recorder or
Step 6. Press the keyboard ESC key once to return to the Advanced menu.
Step 7. Select Integrated I/O Ports and press Enter to access its submenu.
Step 8. Select Serial Port B and press Enter to access its submenu.
Step 9. Press the keyboard ESC key twice to access the BOOT menu.
Step 10. Select Quickboot Mode and press Enter to access its submenu.
Step 11. Change its value to Disabled and press Enter.
Step 12. Press the keyboard ESC key once to access the Exit Menu.
Step 13. Select Exit Saving Changes and press Enter to access the Setup Confirmation
Step 14. Select Yes to Save configuration changes and exit now? and press Enter to
If only changing the BIOS settings, remove the floppy from the PC and reboot. If using the
FIST floppy as part of an installation, the Philips system will then return to the blue HP
Kayak PC Workstation screen and the installation process will continue. When the MS
DOS 6.22 Startup Menu reappears:
Step 15. Enter 4 [D6723T - Kayak XA (Series 05xx)] or 5 [D6731T - Kayak XA (Series
Step 16. Follow the OS installation procedure described in Operating System
7-134
Maintenance, Troubleshooting, and Repair
the F2 key.
arrow key.
press Enter.
external modem is connected, set IRQ 3 to Available.
• If no 4-Channel Recorder or external modem is connected: change the value to
Disabled and press Enter
• If a 4-Channel Recorder is connected, change the value to Enabled, 2E8, IRQ3 and
press Enter.
• If an external modem is connected, change the value to Enabled, 2F8, IRQ3 and
press Enter.
window.
save the changes.
05xx)] after Enter a choice: and press Enter.
Installation.