Pcs - Philips M3150B Installation And Service Manual

LC 2000 Server BIOS are contained on the HP NetServer LC 2000 BIOS Upgrade Disk in the
holder on the side of the Server. If the LC2000 BIOS floppy disk is lost or has failed, a new
one can be made. Refer to "Creating Server BIOS Bootable Floppy Disk" on page 7-
146. The procedure for updating Server BIOS is as follows.
Step 1. Insert the NetServer LC 2000 BIOS Upgrade Disk into the A:\ drive of the Server.
Step 2. Shutdown and Restart the Server following proper shutdown procedure.
When the BIOS Update Utility window appears:
Step 3. Press the keyboard 1 key to begin the update.
The BIOS updating process takes about 8 minutes.
Note If an Incorrect System Configuration message appears, press the keyboard F1 key to
continue. The correct system configuration is setup later in the procedure.
When the BIOS Update Utility window reappears,
Step 4. Press the keyboard 2 key to exit the BIOS Update Utility. The Server will
Step 5. REMOVE the HP NetServer LC 2000 BIOS Upgrade Disk from the Server's A:\
When Press <F2> to enter Setup appears at the bottom of the screen,
Step 6. Press the keyboard F2 key and the Phoenix BIOS System Configuration window
Step 7. Perform the System Setup procedure for the HP P2478WA Net Server LC
Note The F2 Key MUST BE PRESSED when Press <F2> to enter Setup is displayed to access
the Setup menu. If you forget to press F2 and the System Setup procedure is not
followed, Philips software installation may fail. To recover, Shutdown and Restart the
system following normal procedures and remember to press F2 when Press <F2> to enter
Setup appears.

PCs

PC BIOS are contained on the BIOS Upgrade Disk in the holder on the side of the PC. If
the BIOS floppy disk is lost or has failed, a new one can be made. Refer to "Recreating
Information Center BIOS Disk" on page 7-145. The procedure for updating PC BIOS is
as follows.
Step 1. Insert the BIOS Upgrade Disk into the A:\ drive.
Step 2. Shutdown and Restart the PC following proper shutdown procedure.
When the BIOS Update Utility window appears:
Step 3. Press the keyboard 1 key to begin the update.
The BIOS updating process takes about 8 minutes.
automatically shutdown and restart.
drive and place it in its holder on the side of the Server.
appears.
2000 on page 7-126.
Maintenance, Troubleshooting, and Repair
Troubleshooting
7-121