User Wires And Pneumatic Tubes - Epson C12 Series Manipulator Manual

Setup & Operation 3. Environment and Installation

3.6 User Wires and Pneumatic Tubes

■ Only authorized or certified personnel should be allowed to perform wiring.
Wiring by unauthorized or uncertified personnel may result in bodily injury and/or
malfunction of the robot system.
CAUTION
User electrical wires and pneumatic tubes are contained in the cable unit.
B
34
One-touch fitting for
ø6 mm pneumatic tube
(Air1, Air2)
Detail of C :Cable downward model
User cable connector
(15-pin D-sub connector)
F sensor
cable connector
Ethernet cable
connector
Power cable
C
Detail of B
One-touch fitting for
ø6 mm pneumatic tube
(Air1, Air2)
Ethernet cable connector
User cable connector
(15-pin D-sub connector)
F Sensor cable connector
Detail of A: Cable backward model
F Sensor cable connector
Ethernet cable connector
Standard model: Cover
Clean-room model: Exhaust port
A
(One-touch fitting for
ø12 mm pneumatic tube)
User cable connector
(15-pin D-sub connector)
Standard-model
: Cover
Clean-room model
: Exhaust port
For ø12 mm pneumatic tube
For ø6 mm pneumatic tubes
(Air1, Air2)
Signal cable
C12 Rev.3