Table of Contents
Advertisement
7 Maintenance
7.1 Introduction
General
This chapter details all maintenance activities recommended for the FlexPLP.
It is based on the maintenance schedule specified in
page
including intervals and refers to procedures for the activities.
Each procedure contains all information required to perform the activity, including
required tools and materials.
The procedures are gathered in different sections and divided according to the
maintenance activity.
Safety information
Observe all safety information before conducting any service work!
There are general safety aspects that must be read through, as well as more specific
safety information that describe danger and safety risks when performing the
procedures. Read
Precautions
The precautions below should be observed before proceeding with the maintenance
of the FlexPLP:
Required equipment
Equipment
Handling equipment
Standard toolkit
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Bolts and screws and tightening torques
Specified in
Product manual - FlexPLP IRPLP 220
3HAW050041018-001 Revision: C
115. The schedule contains information about required maintenance activities
Safety on page 13
CAUTION
•
Before any intervention on the mechanical and electrical components, all
power supplies to the FlexPLP as well as to other machines within the danger
zone must be turned off.
•
If required, the main switch should be locked.
•
Make sure that the pneumatic system is not pressurized.
•
Use only original ABB spare parts. The use of unauthorized parts or others
than original parts will void the warranty.
Bolt, screws, tightening torques on page
© Copyright 2016 - 2018 ABB. All rights reserved.
Maintenance schedule on
before performing any service work.
Note
Specified in
Handling/lifting on page
Specified in
Standard toolkit on page
Specified in
Special tools on page
133.
Continues on next page
7 Maintenance
7.1 Introduction
54.
134.
135.
113
Advertisement
Table of Contents
