Special Tools - ABB FlexPLP IRPLP 220 Product Manual

9.5 Special tools

General
All service instructions contain lists of tools required to perform the specified
activity. The required tools are a sum of standard tools, defined in the section
Standard toolkit on page
and also gathered in this section.
Special tools
The following tables specify the special tools required during several of the service
procedures. The tools are also specified directly in the corresponding section of
instructions in the Product manual.
For operations on pneumatic connectors, the special tools are as follows.
Qty
1
For operations on electrical parts, the special tools are as follows.
Qty
1
1
Special tools available from ABB
The following table specifies the special tools required during several of the service
procedures. The tools may be ordered separately and are also specified directly
in concerned instructions in the Product manual.
Qty
1
2
Product manual - FlexPLP IRPLP 220
3HAW050041018-001 Revision: C
134, and of special tools, listed directly in the instructions
Tool
Thread sealant for conical fittings
Tool
Wire strippers
Cable cutters
Tool
Tension gauge
Calibration pin Ø8 x 50 mm
© Copyright 2016 - 2018 ABB. All rights reserved.
9 Reference information
9.5 Special tools
Product
Loctite 577
Product
Product
3HAW050009048
3HAW050041930
135