Stand-Alone Logiq™ S8; Logiq™ + Pc Within A "Sneaker Net; Connection Between Logiq™ And Dicom Server - GE LOGIQ S8 Service Manual

GE H DRAFT
EALTHCARE
D 5394227, R
IRECTION EVISION
3-11-1-3 Stand-alone LOGIQ™ S8
If digital images or 3D/4D data sets (if available) are stored, they should be saved in the Archive (Image
Management System software).
For Image Management functionality refer to the Basic User Manual of the LOGIQ™ S8.
To avoid loss of essential data, it is highly recommended to export/backup patient data as well as
NOTICE
measurements at least once a month.
!! NOTICE:
Physical Connection:
No network connection needed.
3-11-1-4 LOGIQ™ + PC within a "Sneaker Net"
A PC is used for review and work on studies acquired on one or more LOGIQ™ S8 scanners without
being connected in a network.
The images are first stored on the LOGIQ™ S8 scanner's hard drive (Archive) and then exported from
the scanner's hard drive to a sneaker device (e.g., DVD/CD), and finally imported from the sneaker
device to the PC's internal hard drive.
For Image Management functionality refer to the Basic User Manual of the LOGIQ™ S8.
To avoid loss of essential data, it is highly recommended to export/backup patient data as well as
NOTICE
measurements at least once a month.
!! NOTICE:
Physical Connection:
No network connection needed.
3-11-1-5 Connection between LOGIQ™ and DICOM Server
In this configuration, the LOGIQ™ S8 is configured to work with a DICOM server in a network
environment. Usually, this will be the hospital network. Images are first saved on the local image buffer
on the scanner. At the end of the examination, the images are sent to the DICOM server via a DICOM
spooler. This scenario requires that the scanner is configured to be connected to the DICOM server.
Physical Connection:
You will need one network cable.
1.) Connect one end of the cable to the Ethernet connector on the LOGIQ™ S8.
2.) Connect the other end of the cable to the wall outlet.
NOTE: If a Peer-to-Peer Network is connected to the hospital's network, you may connect the
LOGIQ™ S8 to the Peer-to-Peer Network.
For more details refer to
3 DRAFT (N
Section 3-12 "Configuring Connectivity" on page
Chapter 3 - Setup Instructions
17, 2011)
OVEMBER
LOGIQ™ S8
S M
ERVICE ANUAL
3-44.
3-43