Peripheral/Option Checks; Input Power; Mains Cable Inspection; Cleaning - GE LOGIQ S8 Service Manual

GE H RAFT
EALTHCARE
D 5394227, R
IRECTION EVISION
10-5-2-2

Peripheral/Option Checks

If any peripherals or options are not part of the system configuration, the check can be omitted.
Refer to
Table 10-6
Step
1
2
3
(Bluetooth) Printer
4
5
6
7
10-5-3

Input Power

10-5-3-1

Mains Cable Inspection

Table 10-7
Step
1
2
3
4 Inlet Connector Inlet connector retainer is functional.
10-5-4

Cleaning

10-5-4-1

General Cleaning

Frequent and diligent cleaning of the LOGIQ™ S8 ultrasound system reduces the risk of spreading
infection from person to person, and also helps to maintain a clean work environment.
Table 10-8
Step
1
2
10-8
3 DRAFT (N
Table 3-8, "Approved Peripherals," on page 3-45
Approved Peripheral/Hardware Option Functional Checks
Item
B/W Printer
Verify hardcopy output of the B/W video page printer. Clean heads and covers if necessary.
Color Printer
Verify hardcopy output of the Color video page printer. Clean heads and covers if necessary.
Color Deskjet
Verify hardcopy output of the Deskjet (Bluetooth) printer. Clean heads and covers if necessary.
DVR
Verify record/playback capabilities of the DVR.
DICOM
Verify that DICOM is functioning properly. Send an image to a DICOM device.
Footswitch
Verify that the footswitch is functioning as programed. Clean as necessary.
Verify that the DVD-drive reads/writes properly
DVD-Drive
(export/recall image in Image Management System = Archive)
Mains Cable Inspection
Item
Unplug Cord
Disconnect the mains cable from the wall and system.
Inspect
Inspect it and its connectors for damage of any kind.
Verify that the LINE, NEUTRAL and GROUND wires are properly attached to the terminals, and that
Terminals
no strands may cause a short circuit.
General Cleaning
Item
Use a fluid detergent in warm water on a soft, damp cloth to carefully wipe the entire system.
Console
Be careful not to get the cloth too wet so that moisture does not enter the console.
Caution: DO NOT allow any liquid to drip or seep into the system.
Clean LCD Monitor surface with a fluid detergent in warm water on a soft, damp cloth.
LCD Monitor
Caution: DO NOT spray any liquid directly onto the LOGIQ™ S8 covers, LCD Monitor, keyboard, etc.
Section 10-5 - System Maintenance
17, 2011)
OVEMBER
for a list of approved peripherals.
Description
Description
Description
LOGIQ™ S8
S M
ERVICE ANUAL