Removal Procedure - An Keyboard - GE LOGIQ S8 Service Manual

GE H DRAFT
EALTHCARE
D 5394227, R
IRECTION EVISION
5.) Remove two cables from location [A].
6.) Remove a connector from location [B].
7.) Remove two connectors from location [C].
Location
A
B
C
8.) OP Panel can now be separated from the console.
8-12-3-3

Removal Procedure - AN Keyboard

1.) Remove connector from back of the AN Keyboard (marked
2.) Remove 6 screws around AN Keyboard.
3.) Slowly lift up AN Keyboard from OP Panel.
3 DRAFT (N
C
Figure 8-30 Removal of cable & connectors
Connector
Power/Signal to Host
CN9
Front USB
CN9
Power to Gel Warmer
CN11
USB to Rear Peripheral
CN36
USB to Rear Peripheral
CN37
Figure 8-31 AN Keyboard
Chapter 8 - Replacement Procedures
17, 2011)
OVEMBER
B
Description
LOGIQ™ S8
S
ERVICE
A
below).
M
ANUAL
8-31