Device - GE LOGIQ S8 Service Manual

GE H RAFT
EALTHCARE
D 5394227, R
IRECTION EVISION
Table 3-22
Preset Parameter
Enable DHCP
IP-Address
Subnet Mask
Default Gateway
Network Speed
NOTE: Reboot the system to activate any changes saved from this page.
3-12-5

Device

To add a new device,
1.) Press Add.
2.) Type the device name in the Name field.
3.) Type the device's IP address in the IP Address field.
Table 3-23
Preset Parameter
Add/Remove
Ping
Properties: Name
3-46
3 DRAFT (N
IP settings
DO NOT select this box to enable dynamic IP Address selection.
NOTE: The system shall disable IP-Address, Subnet Mask, and Default Gateway when the user
chooses to use DHCP.
Type the IP Address of the Ultrasound system. NOTE: IP stands for Internet Protocol. Every
device on the network has a unique IP address.
Type the subnet mask address. NOTE: The Subnet Mask is an IP address filter that eliminates
communication/messages from network devices of no interest to your system.
Type the default gateway address.
Select the network speed (Auto Detect, 10Mbps/Half/Full Duplex, or 100 Mbps/Half/Full Duplex/
1000Mbps/Auto-negotiate)
Figure 3-26 Connectivity Device Preset Menu
Device
Press Add to add a new device; press Remove to delete a device.
Press Ping to confirm that a device is connected.
Type the name of the device.
Section 3-12 - Configuring Connectivity
17, 2011)
OVEMBER
Description
Description
LOGIQ™ S8
S M
ERVICE ANUAL