GE LOGIQ S8 Service Manual page 93

GE H DRAFT
EALTHCARE
D 5394227, R
IRECTION EVISION
Table 3-10
Preset Parameter
Color Level (restart needed)
Table 3-11
Preset Parameter
Hide Patient Data
Font Size (restart needed)
Table 3-12
Preset Parameter
Speed
Acceleration
Table 3-13
Preset Parameter
Run Fast Key speed
Swap Print1/Freeze Key
(restart needed)
Table 3-14
Preset Parameter
Prompt for Save on Exit
Utility Font Size
3 DRAFT (N
General User Interface
Select System Color according to the condition of the room.
Title Bar
When set to Always, patient information is removed from the scanning screen Title bar and
when storing images; or you can set this to remove patient information only when storing
the image (On Store); or Never.
Note: Upon recall of images with measurements, Dual image, V Nav, the DICOM image is
recalled. In this case, there is no patient data burned into the DICOM image. If you DO NOT
want this to occur, set this to Never.
Select to display patient information in the title bar using a small, medium, or large font size.
You need to reboot the system for this change to take effect.
Trackball
Set how fast you want the Trackball to move while performing actions such as tracing the
anatomy. 0=Slow; 20=Very Fast
Set how fast you want to trackball to move across the display. 0, 1, and 2 with 0 being the
slowest acceleration.
Key Usage
Select the maximum value of the key interval when running Fast Key.
Swap the control between Print 1 and Freeze key.
Utility
If selected, the system prompts you to save data when you select exit without saving.
Select the font size you want to use to view the Utility menus: Small, Medium, or Large.
Chapter 3 - Setup Instructions
17, 2011)
OVEMBER
Description
Description
Description
Description
Description
LOGIQ™ S8
S M
ERVICE ANUAL
3-35