Base Side Fittings - Epson C Series Manual

C4 Manipulator 6. Options

6.5 Base Side Fittings

Using the base side fittings to the C4 Manipulator base, you can mount the Manipulator in
the place where limits the mounting height or use the open room for the base.
Mounting image using the base side fittings
For the information on how to mount and precautions, refer to "3. Environment and
Installation".
A
B
C
To mount the base side plate
For details of tightening the hexagon socket head screws, refer to "Regular Inspection 1.4
NOTE

Tightening Hexagon Socket Head Bolts"
(1) Drive the pins to the base side plate.
(2) Mount the base side plate with the pins driven to the both sides of the base.
74
Parts included
Base side plate
Pin
Hexagon socket head
screw M8 × 60
Protruding part of pins is approx. 2 to 5 mm.
Fit the pins with the holes and secure the base side plate by pressing it from above to
the base fixing part.
(With the steps above, the both surfaces of base side fittings can be stable.)
Qty.
2
2
C
4
Base fixing
part
2. Press toward this face from above
2-M8×60
A
A
B
Pin protruding part
2mm to 5mm
1. Insert pins into
the holes
C series Rev.2
C