User Wires And Pneumatic Tubes - Epson C Series Manual

6.5 User Wires and Pneumatic Tubes

Use the following options when using the internal wiring and tubing for the end effector
drive.
Fitting for customer use (ø6 straight)
ø6 straight fitting
* Attached as standard. The parts can be purchased additionally in case of lost or shortage.
Fitting for customer use (ø6 elbow)
ø6 elbow fitting
* Attached as standard. The parts can be purchased additionally in case of lost or shortage.
Standard user connector kit (D-sub)
Connector
Clamp hood
* Attached to standard and cleanroom-model Manipulators as standard.
The parts can be additionally purchased in case of lost or shortage.
Waterproof User Connector Kit (D-sub)
Connector
Clamp hood
* Attached to the protection model Manipulators as standard.
The parts can be additionally purchased in case of lost or shortage.
Waterproof User Connector Kit (Ethernet)
Connector
* Not attached as standard. Please purchase the item if needed.
Please note that the protection rating IP67 cannot be satisfied if other connectors are used.
C series Rev.2
Item Qty.
Item Qty.
Item Qty. Manufacturer
2
2
Item Qty. Manufacturer
2 HARTING
2 HARTING
Item Qty. Manufacturer
2 HARTING
Manufacturer
2 SMC KQ2S06-M6N
Manufacturer
2 SMC KQ2L06-M6N
JAE DA-15PF-N
HRS HDA-CTH(4-40)(10)
09 67 015 5615
09 67 015 0538
09 45 145 1560
C8 Manipulator 6. Options
Standard
Standard
Standard
(Solder type)
(Connector setscrew:
#4-40 UNC)
Standard
(Solder type)
(Connector setscrew:
#4-40 UNC)
Standard
163