[Ef10] Paper Not Supported For Saddle Stitch Finisher; [Ef11] Saddle Stitch Finisher Stapling Error (Front) - Toshiba e-STUDIO206L Service Manual

[EF10] Paper not supported for Saddle Stitch Finisher

MJ-1106/1108
Classification
Finisher jam (Finisher section)
Check item
Paper
Buffer tray home position sensor
Buffer tray guide motor
Saddle controller board
Parts to be replaced
Buffer tray home position
sensor
Buffer tray guide motor
Saddle controller board

[EF11] Saddle Stitch Finisher stapling error (front)

MJ-1106/1108
Classification
Finisher jam (Saddle section)
Check item
Finisher
Saddle staple cartridge (Front side)
Front saddle stapler drive unit
Saddle controller board
Replace parts
Front saddle stapler drive unit
Saddle controller board
© 2011-2014 TOSHIBA TEC CORPORATION All rights reserved
Unsupported paper size, type and an excess number of
pages for stapling are selected.
• Paper size check
• Sensor check
• Connector check
• Harness check
• Motor check
• Connector check
• Harness check
• Connector check
• Board check
Remark
Front stapling is not correctly done.
• Is there any paper remaining on the paper transport path
in the Finisher or the equipment, or on the finishing tray?.
• Is the jam released by taking off the front staple cartridge
from the Finisher and removing the staple sheet slid from
the staple case?
• Unit check
• Connector check
• Harness check
• Connector check (CN3)
• Board check
e-STUDIO206L/256/306/356/456/506 / 207L/257/307/357/457/507
8 - 115
Error item
Measures
Error item
Measures
Remarks
ERROR CODE AND TROUBLESHOOTING
8